power window roll up module prob

ok guys I have had pretty much everything down on my installations, but this one is stumping me!!!!  I bought two of these to control both my front and back windows up and down.  but I am lost and which wires control what and what they do even though I have the instructions lol.  If anybody can explain these crazy instructions, I would greatly appreciate it!!! THANKS!!!

Here goes you're going to have to find each pair of wires for the windows.  The wires should rest at ground and when you push the up/down button one of the wires will go to +12v.  You can probably get all four pairs at the master switch.  Once you locate all the wires, you'll have to cut each pair in half.  I would recommend doing that 1 window at a time so you don't get all confused.  Then wire up the controllers as follows.

BLACK/ white loop - cut it and isolate each end of the wires

Wire up the second controller the same as the first just use the rear windows.  Good luck hope this helps you

Does that window module raise both windows at the same time?  Where did you pick it up from?

Nope! Looks like asianwolf product instructions. It does one window at a time, unless you have the TWO window module. That one does both windows simultaneously.