Remote Start, ’04 Grand Am, ’04 Intrepid

There is a port on the side of the 1270 with ground-negative trigger-power this port if for the ignition bypass/interface.

They sent me a 1250!!!!! so i'm missing that harness, which explains a lot.  Here's how I intend to wire things up, correct me if I'm wrong.  I'm guessing on the GM harness until I have the car in front of me, but here's what I have so far.

Heavy Power Harness-GM Harness: Red's-reds, yellow-yellow/black, green-WHITE/ black, white-WHITE/ red, blue-white

Main harness to Vehicle or GMDL-BP    Yellow-Not used;  Red-Orange(GMDL-BP);  Brown-Not used;  Orange-???; WHITE/ Blue-Black(bcm); BLACK/ white(not there);  Purple(not there);  White-Brown(bcm);  GREEN / WHITE-hood pin;  Black-Chassis ground;  Pink-White(brake switch);  blue/white-Wire(pcm)(not sure which engine she has);  blue-not used

Door lock green-green(GM), Red(Not There) Door lock Blue-blue(GM)

Instant Start(Not There)

Antennae plug is obvious

THe Ground while running/Ground Output/12volt output, isn't there on the f'n 1250 they sent me, but thanks to the above post, I use those to hook into the power, ground, and ground while running wires on the GMDL-BP

Does all this look right?  Since I'm probably getting stuck with this unit, will the 1250 easily work with the intrepid?