06 Toyota 4Runner Remote Start, Windows

I forgot how to wire the relay but one is constant 12v, one is ground, one is aux output (- trigger), and one is out to sunroof switch. I know 87a was not used. run the output wire up the side and up into the overhead console. You may have to pull the pillar panel and some weatherstripping.

First pull down the overhead console at the front near the windshield. There's a harness plugged into the motor right there.

Alway test w/ a multimeter!

Constant- blue/ orange (thicker wire)

Ignition-BLACK/ red

switch close- gray

cut the ignition and splice the motor side wire (the one on the harness side)into 12v constant. Now you can operate it without the key in the ignition.

then tap the output into the gray switch close wire. I imagine you could do the same for open, but I haven't tried it. Vent is good enough for me.

I got the 2 530T's in yesterday and installed them.  The 4 runner I was working on was a sport and would not roll down with the keylock in the drivers door. I used the wires at the switch itself in the drivers door.  The wires in the drivers kick panel change colors.  Since I did it all in the Drivers door, I only have those wire colors. Also, I didn't bother to write down which one was up and which one was down. (I was already running late!) . You'll have to test them with your meter. They where type A wiring. Here's the info I Got:

light green -     driver rear

blue w/2 silver dots -    driver front

pink/black stripe-   passenger front

pink/blue stripe-   passenger rear

Hopefully this will save someone some time. Frank