1998 Cavalier, alarm/remote start

Is there a way to get to the Keysense wires with out takeing off steering wheel shroud(plastic thing)

I think i can get the Ign wires in a big loom under the dash but didn't know about the keysense wires.

Also well were still here,where is a good place to mount the brain,i know its a very open under there.

Also this car doesn't have power locks so im adding them

He wants truck pop,but do i need to go all to the trunk.would i find it like on the Keyless cars in a wire in the kickpanel.

Could some please draw me a realy as well,the alarm output is (-) and it says the trunk is (-)

Hi all i hope i word'ed in right

the car is a 1998 Cavailer

I need a diagram to wire up a (-) trunk pop,can't seem to find one at all

also do i need to go right to the trunk latch or can i get the wire in the kickpanel like on the keyless cars.

any help would be grat.

spookiestylez wrote: Yeah, you should be able to get the wire you need in the kick panel.Also be sure to use a DMM to test all your wires GL sS

Don't i need to use pin 30 for the device as thats the comon pin,i see (12v) and Neg output and ground

Or do i use 87a for to activate the trunk wire

spookiestylez wrote: Yeah, you should be able to get the wire you need in the kick panel.Also be sure to use a DMM to test all your wires GL sS

Do i use pin 87a to activate the trunk pop wire then

because i see 12+, neg out and ground

also isit pin 30 the common pin,woulded that go to the trunk wire

The key sence on this rig is in the black conector on the ign. harness.

Your trunk pop only comes on the cars with keyless entry (factory) it's found in the trunk. Behind carpet left sied of trunk. blk/wht POS(+)

So that you understand what pin does what. Here is an internal diagram.

Alright i was just going over all my wireing info and yes the factory trunk wire is (+) and the output from the RS is a (-).

So that diagram posted above will work just fine