2005 Silverado 2500HD remote start

Home / the12volt's Install Bay / Car Security and Convenience / 2005 Silverado 2500HD remote start (

Topic Closed)

Welcome Guest :)

Members

< Prev Page Next Page > < Prev Topic Next Topic >

Hymer

Silver - Posts: 695

Joined: November 20, 2004

Location: United States

Posted: January 08, 2007 at 10:32 AM / IP Logged

Dont use it, go with a timer if your concerned. Duramax is so quick most of them wont register...

Tire Proz Stillwater Mn

High End Restyling and Comlete Repair

Hymer

Silver - Posts: 695

Joined: November 20, 2004

Location: United States

Posted: January 08, 2007 at 10:35 AM / IP Logged

If ya want to its dk blu behind the cluster [by the tach] [-]

Tire Proz Stillwater Mn

High End Restyling and Comlete Repair

arhunter

Copper - Posts: 82

Joined: January 06, 2007

Location: Arkansas, United States

Posted: January 08, 2007 at 10:53 AM / IP Logged

Thanks for the reply. I have found the tach wire on the power train module under the hood, but not sure where it is under the dash.

The Duramax will actually start without any delay unless very cold. The glow plugs are supposed to be a max time of 3 seconds.

Hymer

Silver - Posts: 695

Joined: November 20, 2004

Location: United States

Posted: January 08, 2007 at 10:58 AM / IP Logged

Exactly, thats why you don't need to worry about it, most rs units take over three seconds to crank anyway.. There has also been an issue of units not seeing the (-) puls from the wts wire and never cranking.. I just set them as a gas car and off they go, unless the customer requests a time delay.. never had a problem.. The tach is in the harness at the cluster along with the wts and vss wires... real easy to find...

Tire Proz Stillwater Mn

High End Restyling and Comlete Repair

Velocity Motors

Moderator - Posts: 12,488

This member has made a donation to the12volt.com. Click here for more info.

This member has been recognized as an authority in Electrical Theory. Click here for more info.

This member has been recognized as an authority in Fabrication. Click here for more info.

This member has been recognized as an authority in Mobile Audio and Video. Click here for more info.

This member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.

Joined: March 08, 2002

Location: Manitoba, Canada

Posted: January 08, 2007 at 11:10 AM / IP Logged

Depending on the RS your using you may have a diesel wait to start delay built into the unit. Compustar's have this feature as a standard feature but requires the programmer to set it up in it's programming.

Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

Search for other posts by Velocity Motors

arhunter

Copper - Posts: 82

Joined: January 06, 2007

Location: Arkansas, United States

Posted: January 08, 2007 at 12:01 PM / IP Logged

Thanks guys.

arhunter

Copper - Posts: 82

Joined: January 06, 2007

Location: Arkansas, United States

Posted: January 09, 2007 at 6:10 AM / IP Logged

Does anyone know if the GM-SL2 Datalink is compatible with Crimestopper RS 1905 FM Data Port?

ziggyb222

Silver - Posts: 593

Joined: January 04, 2004

Location: Maine, United States

Posted: January 09, 2007 at 7:11 AM / IP Logged

I believe all crimestoppers are compatable with the GM-SL2.. I just did a Buick yesterday with the 1304 Crimestopper and the GM-sl2..Slick set up..

arhunter

Copper - Posts: 82

Joined: January 06, 2007

Location: Arkansas, United States

Posted: January 10, 2007 at 7:20 AM / IP Logged

I want to control the rear defrost with one of the remote start auxilliary outputs (Crimestopper RS 1905 FM). Does anyone know where the rear defrost signall wire is located? I assume it is a momentary pulse from the pushbutton switch in the climate control section of the dash. I would like to find the easiest access to this wire. Also, would this be a sinking or sourcing signal?

KarTuneMan

Platinum - Posts: 7,056

This member consistently provides reliable information

Joined: December 14, 2004

Location: Isle Of Man

Posted: January 10, 2007 at 8:08 AM / IP Logged

Pin A8 in the gray connector at the BCM under the dash White wire NEG(-) needs a "latched pulse. This will NOT turn on the indicator light, OR the heated mirrors, but WILL turn on the defroster.

< Prev Page Next Page >

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.