viper 150 esp/xcrs 500m, 87 bronco

Nothing is hooked to the thick grey/yel wire.  The Grey / YELLOW drives the wiper motor mostly.

I got it fired up.  Still need to learn the tach, not sure how to do it, but then again do I because it already runs?  Still need to go though the programming.  I perfer everything to be active.  I do not want it to do anything unless I tell it to.

The BROWN / pink must run the a/c, because it is working on the remote start. 

The BLACK/ white safety hooked to the switch and then to the ground.  The tap for the start wire is directly off the ignition switch and the neutral safety is down current, so I should be in good shape correct?

Still testing.  The anti-theft is working, locks, lights, horn as well, brake shuts it off.

Still need to do hood pin, redo one set of wires.  I think I have the xcrs purple and green backwards.  If I connect them the starter works, apart it does not.  I'd like to have the anti-grind.  Mount the shutoff switch and tuck up the wires securely.

Had the start wires backwards - now it works.  Anti grind works.  Hood pin works. Dome light works.  I think I have it down.  Still have to teach the tach and tuck up wires.

All I am not sure of is the safety switch (BLACK/ white wire and switch), but I think it is right.

Thanks for the BLACK/ white wire info.

Got it, I'll set the idle today.  What does it control or monitor?  How?  Should this be done with the engine hot or cold? 

BTW, thanks for all the help.