avital 2101l keyless entry in 1998 s10

I just bought an Avital 2101l with some factory keyfobs for my '98 S10. Now I have the basics of installing alarms, circuits and what not but this keyless entry system is looking pretty hard. I have not started the install, but would like some help with the wire connections. Especially the ones that have to do with the lock and unlock relay connections. Do I make those on the truck, or just the 30 output wire?  Thanks

what exactly do you have questions about? As for the lock wires, if your vehicle requires a positive pulse, you want to send 12v to 87 for lock and unlock and then send 30 to the appropriate lock or unlock wire.

Door Trigger	White (-)	Courtesy Light or at BCM Tan DR.+ Orange PAS
Door Lock	Light Blue (+)	Driver's Kick Panel or Brown Connector at BCM
Door Unlock	White (+)

It looks to me as though they are positive fed. So does the 87 need to go to 12V?

sorry didn't see the corrected reply you had sent before asking.

What about the H1/3 and H1/4 connection?

H1/3 BLACK/ White - DOMELIGHT SUPERVISION RELAY #87 (IN)

H1/4 BLACK/ White - DOMELIGHT SUPERVISION RELAY #30 (OUT)

Also just to clarify, the H1/6 and the H1/17 do not get connected?

H1/6 WHITE/ Black - LOCK #87A NORMALLY CLOSED

H1/17 BROWN / Black - UNLOCK #87A NORMALLY CLOSED