clifford 590.2x

Im putting in a clifford 590.2x with window module and a DBALL xpresskit, I need wiring diagrams and locations please.

Sorry its for a 2005 Honda Accord EX V6

Look on the vehicle wiring section please.

Ok i need help finding where to connect these wires to H2 harness 18pin -H2/10 status output -H2/11 flex relay control output -H2/16 status output two H3 harness 10pin -H3/1 ignition 1 input/output -H3/6- fused 30A ignition 1 input H3/9 fused 30A accessory/ starter input For H2/12, H2/13,H2/14 (accessory, starter and ignition output) can they be tied into the remote start harness wires Remote H3/1, H3/3, H3/4

You will need to find, test and verify ALL wires on your car before connecting wires from the remote start unit. 

If you don't have a DMM for testing, you are Guessing.  Download the Viper 5701 install manual from this site. On page 13 is a section on how to find the wires you need.

Do a search on this site for other info on a 2005 Accord that might help you.

Car                                                                                              R/S Unit

12 volts constant  (White)+                                                     H3/2, 6, & 9

Starter (BLACK/ White) +                                                            H3/5

Ignition 1 (BLACK / YELLOW) +                                                      H3/1

Accesory 1 (BLACK/ Red) +                                                        H3/3

Accesory 2 (WHITE/ Red) +                                                        H3/7  Will have to be set as Accessory

H2/10   connects to your bybass module

Wiring Chart from the Bulldog Guys:  http://www.bulldogsecurity.com/bdnew/vehiclewiringdiagrams.asp

When all else fails, Read the Instructions

Support the12volt.com Make a Donation

The H2/12, 13, 14 wont be used on this vehicle