of viper 5101 with dball?

Ok i have done several hours of reading and am now going to tackle this project I thing i have all basics covered i will be doing the d2d setup

6 pin harness

h1 is this the red white or can i use any constant 12v source

h2 ground H3 brown horn 24 pin tan/pink bcm H4white lt blue grey bcm

door lock 3 pin d2d

8 pin

h1+ ign 1 out pink to pink ignition wire

h2  + 12v constant input red white to red white ign wire

h3  + acc. output orange to orange at ign

h4 violet not used h5 red not used

h6 ign 2 flex output pink white to brown at ign?

H7 ???? flex relay output87a if req i dont think i need

h8 + 12v constant input for acc and start red black to red white (seems like a lot of wires running to redwhite ign wire

dball

in the 12 pin it says to conect the black white RAP off What is that???

What is bulb test passlock 1 only mean?

The rest i think i have other then the door - to positive thing but do i even have to hook these up on the remote start or dball side? I had my wifes last car done professionally and you could not open doors with remote start fob and and had eto shut off car using remote start remote and then unlocking doors with car factory fob or just use the key to get in so my wifeis used to this anyway

Thanks for any input good or bad i did a few of these years ago in some chrysler but no the theft or bypass stuff needed then Thanks I do have the loader to flash dball befor install as well

This is for a 2005 chev equinox lt soory thanks

You won't need the Bulb Test wire on this vehicle.  RAP is Retain Accessory Power.

Link to the info provided to me:  https://www.the12volt.com/installbay/forum_posts.asp~TID~132274~KW~smokeman1~PN~1~TPN~1

i think i found the rap wire grey black at pink connector in bcm