code alarm ca6550 remote start 98 inte

I'm trying to install the remote start on a 1998 Integra Sedan.. Im done with everything and I connected everything. I'm not sure if I connected everything. can some help me what on the list is important to connect off the Code Alarm CA6550.. I'm not sure in I need a Mobilizer on this car. Everytime I try to start the remote start but it flashes 3 time saying Remote Start Shutdown Diagnostics If the remote start shuts down or fails to start, the parking lights will flash one of the patterns below indicating the shutdown input. To manually enter diagnostics and view the last shutdown, turn the ignition ON and press and release the button. LED FLASHES SHUTDOWN ZONE 3 Flashes Hood Input Brake Input 4 Flashes Remote Start Valet Mode 7 Flashes Tach not learned / Crank Average not learned

First step would be to disconnect your brake and hood wires. See if it helps. Did you ground the neutral safety wire?

neutral safety wire (-) should I connect this to the Emergency E-Brake?

Nope. You could, but then you would need to set the e-brake whenever using the remote start. Just ground it.

Ok I tried disconnecting the hood and brake input... The major problem was to program the TACH while running.. I got it to where I enable the remote start then the all the lights come up ready to firing but no cranking up like I hooked up the main wires wrong.. I connect both pink/white and Pink I'm so close Weird is when I remote start is enable I put the key in and just start the car. I can remove the key and the cars still running

Could you list what wires from the remote starter are connected to what wires on the car?  It would help us to understand what might be going on.

I don't think you need the pink/white wire for starters.

When all else fails, Read the Instructions

Support the12volt.com Make a Donation

Constant 12V+     White      Ignition Switch Harness Starter      BLACK/ White       Ignition      BLACK / YELLOW Ignition 2      WHITE/ Black       Accessory      Yellow       Tach      Blue      Distributor Neutral Safety Wire      GREEN / WHITE       Brake Switch      GREEN / WHITE       Trunk Pin      Green (-)       Parking Lights      RED / Green       Hood Pin      n/a      

Is the Neutral Safety Input connected to the same GREEN / WHITE as the Brake Input?  Is this vehicle manual or  automatic? When all else fails, Read the Instructions

Support the12volt.com Make a Donation