2001 impala wi dball , polar start cs3371

Greetings, I have a ProStart ( same as Astrostart and Viper) 4 button Remote Starter. This unit has the D2D port and is connected to the DBall. I flashed the DBall (twice) to GM2 and it was successful. The only wire hook ups I have are the Orange for the OBDII port. It is connected (soldered) and a continuity test shows good between the data port purple and the DBall Orange. I can't get the LED to turn green... As I understand it, I should... Hook up all harnesses except the data cable Hold the programming button and plug in the data cable Wait until the LED is amber Release the button LED turns Red Start the car Wait for Green LED The LED never changes... Stays solid red forever... I have an OBDII Scan tool and the data port works and the continuity to the Dball is fine... Any advice on this? Thanks, Steve Steve

"All in favor of safer highways, raise your right FOOT"

I noticed you said the orange wire from the DBALL is going to the OBD II violet wire. I don't see an orange wire on the install manual?? There is a violet / YELLOW wire on the blue harness pin-2 that is supposed to go to the violet wire pin-2 of the car's OBD II connector.