06 ford fusion s w/ crimestopper rs 4 g4

Hi all, I'm looking for some help installing the crimestopper RS-4 G4 into my 06 Ford fusion S. The only function I want is the remote start from my OEM key fob. I have found wiring diagrams and the like and have the following connected so far: 12 VOLT CONSTANT BROWN / RED (+)      @ the battery STARTER      BLUE/WHITE (+)      @ IGNITION SWITCH HARNESS       IGNITION 1      WHITE/ ORANGE (+)@ IGNITION SWITCH HARNESS       ACCESSORY /HEATER BLOWER 1 PURPLE / GREEN (+)@ IGNITION SWITCH HARNESS       PARKING LIGHTS ( - )      GRAY (-)      @ HEADLIGHT SWITCH POWER LOCK      GRAY / YELLOW (TYPE B)      IN DRIVER KICK PANEL       BRAKE      PURPLE / WHITE (+)      @ SWITCH above BRAKE PEDAL I also have the tach wiring running to a ignition coil. ok, there are a few wires not connected yet but when I plug in the harnesses to the RS4 "brain" I get relays clicking and the dash lights up along with the "door ajar" ding. The LED is lit dim and it just cycles through this until I unplug it again. I'm afraid I might mess something up if I continue so I'm looking for assistance. I would also like help in continuing the wiring. Thank you

connect the ground wire on the remote start.

Sorry I forgot that one. It is connected to a good body ground.

So I rechecked the Ground, 12v, ignition, and the account/blower wires they all seem to be correct. So that leads me to believe that its one of the "trigger" wires are incorrect. Also, do I need to have the antenna hooked up?

Accessory not account. Autocorrect :)

It was the door lock wire. I need to program the unit for the OEM setup first. Thank you for all the replies.

With the OEM keyless entry do I need to connect the OEM alarm disarm and rearm wires from the crimestopper? If so, what wires do I use since my wiring diagrams don't specify these two wires?

YOU NEED A BYPASS MODULE LIKE A KEY OVERRIDE-ALL 12volts       WHITE/ red (60A), red (60A)       +       SJB, conn. F, pins 1 and 2       Starter      blue/white      +      ignition switch, 7 pin plug, pin 7      Second Starter      N/A                  Ignition      WHITE/ orange      +      ignition switch, 7 pin plug, pin 1      Second Ignition      N/A                  Third Ignition      N/A                  Accessory      PURPLE / green      +      ignition switch, 7 pin plug, pin 6      Second Accessory      N/A                  Keysense      blue/gray      +      ignition switch, 7 pin plug, pin 5      Power Lock      gray / YELLOW (test with pass sw if equip with mem)      -      driver kick or SJB, conn. C, pin 4      Power Unlock      PURPLE / gray (test with pass sw if equip with mem)      -      driver kick or SJB, conn. C, pin 10      Lock Motor      gray/brown      5 wire      driver kick or SJB, conn. E, pin 17      Unlock Motor      blue/green (without memory)      5 wire      driver kick or SJB, conn. E, pin 27      Parking Lights+      gray / YELLOW      +      driver kick or SJB, conn. A, pin 31      Parking Lights-      gray      -      switch or SJB, conn. D, pin 5      Hazards      BROWN / yellow      -      switch or SJB, conn. D, pin 20      Turn Signal(L)      blue/green (F); gray/brown (R)      +      SJB, conn. A, pin 21; conn. E, pin 11      Turn Signal(R)      yellow/purple (F); PURPLE / orange (R)      +      SJB, conn. A, pin 9; conn. E, pin 7      Reverse Light      GREEN / WHITE      +      driver kick or SJB, conn. E, pin 21      Door Trigger      GREEN/ purple      - N.C.      driver kick or SJB, conn. C, pin 11      Dome Supervision      blue      +      driver kick or SJB, conn. E, pin 16      Trunk/Hatch Pin      yellow/orange      - N.C.      driver kick or SJB, conn. C, pin 6      Hood Pin      blue/orange      - N.C.      pin switch or SJB, conn. A, pin 27      Trunk/Hatch Release      brown      -      switch or SJB, conn. D, pin 27      Power Sliding Door      N/A                  Factory Alarm Arm      PURPLE / green and YELLOW /GREEN (driver door keypad)      both -      driver kick or SJB, conn. C, pins 16 and 21      Factory Alarm Disarm      PURPLE / brown (driver door key unlock) (w/o memory)      -      driver kick or SJB, conn. C, pin 5      Disarm No Unlock      see factory alarm disarm                  Tachometer      NOT WHITE/ blue      ac      any fuel injector      Wait to start      N/A                  Brake Wire      PURPLE / white      +      switch or SJB, conn. A, pin 19      Parking Brake      gray/blue      -      switch or SJB, conn. C, pin 9      Horn Trigger      blue/white      -      switch or SJB, conn. B, pin 6      Memory Seat 1      PURPLE / white      -      Driver Door Module in door, 24 pin plug, pin 4      Memory Seat 2      yellow      -      Driver Door Module in door, 24 pin plug, pin 16      Memory Seat 3      N/A      -            MAKE : FORD | MODEL : FUSION | YEAR : 2006

Factory Alarm Arm      PURPLE / green and YELLOW /GREEN (driver door keypad)      both -      driver kick or SJB, conn. C, pins 16 and 21       Factory Alarm Disarm      PURPLE / brown (driver door key unlock) (w/o memory)      -      driver kick or SJB, conn. C, pin 5 Lock Motor gray/brown   5 wire   driver kick or SJB, conn. E, pin 17 -CONNECT TO GREEN(start activation)WIRE ON RED 3 PIN HARNESS

prdjr165 wrote: Factory Alarm Arm      PURPLE / green and YELLOW /GREEN (driver door keypad)      both -      driver kick or SJB, conn. C, pins 16 and 21       Factory Alarm Disarm      PURPLE / brown (driver door key unlock) (w/o memory)      -      driver kick or SJB, conn. C, pin 5 Lock Motor gray/brown   5 wire   driver kick or SJB, conn. E, pin 17 -CONNECT TO GREEN(start activation)WIRE ON RED 3 PIN HARNESS

OK thanks. One extra question, I don't have a keypad on the outside. Also, the the gray/brown for the lock motor, will that give me the (-) negative pulse?