90 Integra, and Remote starter install

Ok I received a remote starter for Christmas, just going to go install it. I have done remote starter installs before but here is my problem I am having. The remote starter i got only has 1 ignition line output. On my 90 Integra there is 2 ignition lines, one I think runs the car itself and the other runs the accessories in the car like the blower motor. How can i hook this starter up so it can run both the ignition lines?

relay it..   85 ground 86 +12v from the ignition1 output 30 +12v from 12volt source and 87a to ignition 2... should do the trick -MikeDriving a Bagged, Caddied 02 s10

sorry typo.. thanks for the catch bobkDriving a Bagged, Caddied 02 s10

Ok so I hard wire the ignition like from the starter into the 1st ignition then from there take a jumper wire to 86 then ake another jumper wire and attach one end to 87 and the other end of that wire to ignition 2 correct?

connect ignition1 like you normally would... then get a relay(those ones with the harness work great) and tap into the ignition 1 wire on the r/s harness with 86. ground out 85. then tap into the 12volt source you are using for the r/s and tap 30 into there. then take 87 and tap that into ignition 2 just as you did with ignition 1.Driving a Bagged, Caddied 02 s10

Ok so basically what I said is correct then by reading what meltingplastic just put.

Ok yea, I fogot to mention the ground and the R/S ignition....

Ok I did exactly what Meltingplastic said to do with the relay and now under normal starting with key the car will not start, but when i remove the relay it does.

Nope I just spliced in,

I have a stack of them here,