98 ford windstar remote start

hi...my husband put this remote starter http:///.ca/dll?ViewItem&category=94832&item=5808451732 in a ford windstar 1998 3.0 automatic (no key code)and the problem is when is start the vehicule with the remote the engine is still cranking ,but he know where is the coil ,he have one remote starter before this one ,and he put the tach at the same place, is that a problem with the remote starter? or i have to program the tach on the remote starter ,but i dont see nothing about that in the manual? can you help me tank's edith

ps:sorry for my english i speak french

According to the Ad:

Multiple signal detection for remote start - Tach, High-Voltage & Oil sensor

hi again... he put this wire on the coil at the same place of the first remote starter he have and with the first remote stater all is ok ?

hi... he remove the first rs and put the new 2 way but he put the purple- white wire at the coil at the same place of the 1 rs and the engine still cranking ?

and i dont think the 2 way rs have the programming for the tach i dont see nothing for that in the user manual

What does your Install Manual say for the PURPLE / White wire??

etc.?????

tachometer input or high-voltage sensing input wire.

this input provides the module with information about the engine's resolution per minute (rpm).

connect to the vehicule's tach wire.common location for a tachometer wire are the ignition coil,instrument cluster,fuel injectors,or engine computers.the correct wire shows between 1v to 6v (ac)and fluctuates with the idle of the engine when testing with a multi-meter capable of testing ac voltage.

note:this wire has the same function with the high-voltage sensing input,so it is alternative solution when voltage sensing input does not supply satisfactory operation.if connect to the high-voltage sensing input,you must coil this wire 5 loops onto the high-voltage from the engine distributor .

that what i have in the user manual tank's

mo12v do you have a answer for me