Please help on my Accent 2001 L

Hello , My brother has a Hyundai Accent 2001 L , no power windows , no powers doors, no trunk pin , no hood pin , so pretty much looks really easy to intall , the alarm is the Aladdin 2000, so , I found the diagram and I intalled all the wires , there wasn't  a lot , only the ones for the inition, the door pins , the tach , the brake wire, so then when I finish all  I tryed to setup the alarm and go to valet mode , but the alarm looks dead nothing happen, I can hear  a little  sound in side , like a clock , so now I don't now what to do, if someone can help me please , and sorry for my bad english..

Herson....

check your ground wire.  Do the lights flash?

check the fuse.  If all that is good , you might have a bad unit.....Good luck...

the ground wire is secure and works good, and  the first time I put the P3 then the P6 and the P10 and the  two parking ligths start goin on , so I  disconect it , so I check all the wires and the last time I put everything  together the siren beep 2 time but that it, I can't not going to Valet mode ,------.

Also  I check the starter wire and its shows always show 0 volts , even when the car is running , so please let me know if I have to do something else I forgot the fuses are ok..

Herson,,,

The wire in  the  left  are my car    the ones in the rigth Aladdin 2000

12 V Red , ignition harness     , P6 Red

12 V Red,  ignition harness      ,  P6 RED / white

Accesory Yellow         ,  P6 Blue

ignition Green,            P6 ignition yellow

starter white ,            P6  White start

Ground , chassis ,           P6 Ground  Black

parking lights left and rigth I don't remember the color              P3 yellow

door triger green and green black ( my car only has 2 doors)            P10  +door trigger ,Gray

tach wire Gray, intrument cluster,           P10 tach Gray/black

Brake wire pink,black ,           P10 brake white

siren brown,             P10 siren brown

let me know

Herson...

• You have a (-) door trigger system that requires the BLUE P10 wire to be hooked up to the GREEN or GREEN/ BLACK wires on the car.
• You also need to hook up the PINK wire from P10 to the BLUE wire on P6
• Make sure that the BROWN loop on the side of the casing is CUT for AUTO tranny vehicles
• You can also grab the tach wire at ECM under driver dash, pin 8
• Does LED stay on after you turn the key to ACC and press the program button 3 times and then again  ?

ok thanks    I made a mistake , I installed the door trigger with the  negative P10 blue so its looks like that one is good ,also my car is 5 speeds so i don't have to cut the Brown Loop, now    the LED never goes on no matter what , so    Let me try to put the pink and the blue together and I let you know.

Also I almost forgot , My brother's car I think has a Clutch swith so Do I have to do something about it in order to remote start the car??? Let me know

Thanks once again....

Herson///

If the car is a manual transmission vehicle you need to bypass the clutch. Go here for a relay diagram of what you will need to do:

http://www.velocitymotorsport.com/images/install_notes/107.jpg

Thanks alot , You are always a big help , in my nissan maxima and now in my brother's car ,  I let you know when I intall the relay and the Pink wire ok .

Herson...