viper 5704 when i disarm my viper and the

if your interior light bulbs have power to them all the time and the door when opened grounds their other terminal so they light up, here is how you do it. if your system is not like this.... the following is incorrect.

i am not familiar with the terminal number you posted so i am gonna tell you how i would do it.

using the common bosch style relay to run the domelight supervision, here we go!!!.

terminal 86 goes to constant 12v

terminal 85 goes to the domlight supervision wire

terminal 30 goes to the wire that runs from your car door pin switch (which gets grounded when door is open)

terminal 87a goes to your alarms "neg" door trigger wire

terminal 87 goes to ground

this set-up will disconnect the alarm door trigger while the domelight supervision is activated and the instant domelight supervision stops the alarm will be reconnected.

if anyone has a problem with this or if your interior light operates in a different way than i have described please let me know ASAP so we can make any needed changes.

if you end up using my wiring recommendation, you will have trouble programming features on the alarm because the alarm had to "see" the door open while you program. so make yourself a note somewhere to remember this.   LOL

to program the alarm, you will need to disconnect the domelight supervision wire from the relay while programming is being performed. then once you are done programming, hook that wire up again.

i think my tips for you are not right since you car already has its own timer for the interior lights.

its been a while since we dealt with all this stuff for you so i need to refresh my memory on the whole matter. i will re-read the posts over the next couple days and see if i can offer any advice.

i sure hope someone else can shed some light on this.