pulse horn, lights set up for bike

I have done a few searches but haven't found an answer..

I have installed a keyfob 12v activator on my bike and I want to add a horn beep and or signal light flash for confirmation of activation. I have an led light to show power on but would like the afore mentioned action as well. Just like a door lock/unlock setup on a car.

Is this set up with a relay or circuit board?

Does the keyfob 12V activator have any output wires?   Can we have a link to the instruction manual for the activator?

two imput wires (black ground and red 12v in)

two output wires (black ground and white 12v out)

one green wire (antenna)

I didn't get an instalation diagram just writen info on the wires functions

all the unit does is turn on and off a 12v source.

I have it down to 2 relays, and one capacitor.

I will not be able to give you a multiple beep for either.  But we can make one of the pulses longer than the other.   Interested?

Ok,

here is what I came up with. The key fob will powerup the bike, lights and dash. The rocker switch brakes the starter solinoid coil lead. The ground for the starter solinoid is a case ground.

Please look at the diagram to see if I am going to burn down the bike with this setup.  ahahahahah.,...

Thanks for the effort. I have installed the above system. No one had replied so I went ahead and installed it. SEems to be working very well. I will continue to try and work out the chirp thing too as I think that would be cool on a bike.

This bike is done and on to the next one.  http://www..com/watch?v=RDZUgdCNC9c

cheers,

Rob