remote start, 2007 accord

I'm hooking up an avital 4113 to my 2007 honda accord and I see that it has all of these wires for things like door locks and factory alarm arm/disarm. I don't want any of these features, I simply want it to start up and turn off if anyone hits the break before the key is in the ignition. Is it okay just to wire up these things or will I need the other functions as well?

Yeah u can hook up as little as you like. But still have to do factory disarm or the horn will sound when it starts.

Thanks. I see that it puts a low out for the arm and disarm which is the same as my vehicle requires, but it states that you should hook it up through a relay. Is that necessary?

You shouldn't need to. Those triggers are negative. FACTORY ARM WHITE/ red (-)   At driver's door controller    FACTORY DISARM White (-)   At driver's door controller This module is part of the switch assembly inside the driver's door. You must run 2 wires through the door jamb boot.

No need for relay. Wires are in door or driver bootTed

2nd Year Tier 1 Medical School

Still installing as a hobby...pays for groceries

Compustar Expert

Thanks for all the help guys, I really appreciate it.

I just finished the installation, but I'm having a bit of a problem. When I press the remote start button, the car will crank for about 6 seconds and try again 2 more times, but will not actually start. The Avital installation manual said I might have a switch-up on my ignition or accessory wires, but I've double checked my connections and know that they are correct. If I leave the key in Accessory before pressing the button it works correctly. Anyone run into this issue in the past? On a side note, there is one more 10 gauge wire in the ignition harness that is WHITE/ red. According to the wiring diagram on this website, it is a keysense, but it behaves like an accessory wire. Is it possible I need to hook that up?

What bypass did you use? I assume you used one....A DMM is a beautiful thing.

MECP Advanced Installer Certified.

xk05 and i programmed it to the pkh3 2.00

12volts       white (50A)       +       ignition harness       Starter      BLACK/ white      +      ignition harness      Second Starter      N/A                  Ignition      BLACK / YELLOW      +      ignition harness      Second Ignition      N/A                  Third Ignition      N/A                  Accessory      BLACK/ red      +      ignition harness      Second Accessory      WHITE/ red      +      ignition harness WHITE/ red is second accessory. Have you verified that ALL of these wires are getting what they should be getting when attempting to remote start?A DMM is a beautiful thing.

MECP Advanced Installer Certified.