02 Pontiac Grand Prix, Viper 5704

Door triggers should be at the bcm? Just like the lock and unlock wires? I'm having a lot of trouble locating the dark blue trigger in the passenger kick. If anyone has pictures of there locations I'd be greatful :-) Can I catch the passenger trigger @ bcm? Also is there a way to test for these wires?

Found factory disarm :-D still need some help on door triggers.

Only pic is for drivers side Tan- Door Trigger... This is a pic of the Dis-arm... https://directechs.com/DirectWire/PrintPhotoNotesBox.aspx?VehicleID=5203&Item=fctalm1 Lock: Unlock is right next to it in the Pic... https://directechs.com/DirectWire/PrintPhotoNotesBox.aspx?VehicleID=5203&Item=puM.E.C.P & First-Class

Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!

It wants me to log in to view the picture. Could you post it here or email it to me? alexp1289@gmail.com

If anyone is wondering. I've got all the other wires connected. Just need help on door triggers. This is driving me nuts. Its like where's Waldo only a f'ing wire 0_0

Does poking the correct wire with a test light (door trigger) set off the alarm? Or is there a better way to test for the wire?

You can use a meter to test the door trigger. The wire should show ground when the door is open. Here is what I show for the door triggers: The tan is located in the drivers kick and catches only the drivers door. The dark/blue is located in the passenger kick panel and catches all other doors, must diode isolate these wires. Is there a visible door pin on the B-pillar?Kenny

Owner / Technician

KKD Garage LLC

Albany, NY 12205

I found a grey and black wire in driver side kick. When I poke it with test light the dome lights come on (this is with all doors closed). When I open any door the bulb on the test light goes out. The tan wires don't do anything when probed with my test light. On passenger side I found a dark blue that when probed turns on dome light. Did I find the correct wires? Even though its different color in driver kick? I'm so lost.

Stupid tan door trigger was at bcm with disarm and lock wires!! Grrrrrr :-P finally found it. Now to go to bed and work on it tomorrow lol.

Ok so I'm looking for the passkey 3 harness on my ignition. There's a ton of small gauge wires. One set of wires has all the colors I need and there's green tape wrapped around those wires (and there's a connector). I tried tapping into those wires like the diagram said (even looked at the passkey 3 module and it looks like those are the same group of wires I soldered to). Got everything hooked up and car started but I was a little skeptical so I unhooked the connector which was after my soldering joints and the damn car still started!! I figured if passkey 3 wasn't plugged in it wouldn't start? So idk if I got the right wires or not. And not sure how I'd test for the ones I need if I have to redo the connections. Someone please give me some guidance :-)