remote start, 2010 toyota matrix

HI Finally success with Prostart CT-3371. I used only one relay for the second ignition wire which was not energizing during remote start because it was connected to GWR plus shared with ADS . I also checked the voltage at the GWR not even 1 volt dc ,so I connected GWR to ADS directly and used chassis ground for for the relay . Now everything works beautiful except that to unlock all doors I have to hold on to unlock button of the remote for a few seconds to open all doors in compare to toyota key with only two short clicks.I am just wondering if my CT-3310 unit is not defective after all or perhaps I should used an isolation relay but I am not sure how however Prosart manual emphasize to use an isolation diode whenever GWR is used. Just for your info no programming change was carried out since my system is WTW (Prostart tech support).Once again Thank you for all the support ,I did learn a lot and enjoyed every minute of it.Mike The following paragraph from prostart installation manual in regards to GWR: WHITE (–) Ground out when running: CAUTION! If multiple relays or modules are connected to the Ground Out wire, ensure that they are all diode isolated in order to avoid feedback and damaging the vehicle.