the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

passat/dball woes


Post ReplyPost New Topic
< Prev Topic Next Topic >
tkellogg 
Member - Posts: 9
Member spacespace
Joined: April 03, 2009
Location: Nebraska, United States
Posted: December 19, 2013 at 2:34 PM / IP Logged  
I ran the wires for W2W between the dball and 5904 this morning to see if that made any difference. The only change is that now the r/s disables the factory alarm on start. The only wires that tie into the factory alarm are the CAN bus wires. This thing is frustrating as all h*ll. The CAN wires in the pic above are what I'm using, the same pair in the dball install guide, the same in about every other CAN adapter install guide I can find as well. I'm guessing at this point that I have a bad dball or that there is something wonky in the firmware?
Page of 2

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, March 28, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer