2010 ford f150 problems

Just did, that works just like you described, but still no luck with programming. How long do i have to hold the key in each position, and do i have to start the truck. Thank you.

I also noticed that happens only if i start with the remote starter but not when i start with the key, is that suppose to be like that? Thank you.

once you have done the factory reset and locked in which wiring mode on the ads module, then start the key programming you turn the key to the on/run position, do not start the vehicle. You only have to leave it there 3 or 4 seconds but the led on the bypass should light solid red with each key you turn to on position then go outAdvanced

I had the key in for about 10 seconds, nothing happened, but when i was turning it off i noticed a quick red blink. Nothing happened with the second key.

with key off, does the light on the bypass respond when you ground the blue/white GWR? Advanced

Got it working, as before you were right from the very beginning, TX, RX wires were connected wrong. I was looking at the wrong diagram in the manual, for some reason i was sure it should be diagram A when it was diagram E, which was the same but going other direction. Anyways, thank you very much for taking your time to walk me through this, if you ever need any advice on the industrial insulation i'm your man.

hey no problem, glad you got it working.Advanced