2009 Corolla Japanese Made.

I don't have a starter 2. There's only one starter

Does the length of the wire create any issue? I didn't cut much of the wire from viper. They are almost the same lenth, which is quite long.

Time to list all of the wire connectons from the viper to what on the corolla.When all else fails, Read the Instructions

Support the12volt.com Make a Donation

plug in the neutral safety switch, turn to on. Make sure you ground the BLACK/ white on the 24 pin connectorTed

2nd Year Tier 1 Medical School

Still installing as a hobby...pays for groceries

Compustar Expert

Okay: Initial Tested The Key Switch: Pin 1 (White) : Off = 0 ACC = 0 On = 12 Crank = 12 } = Ignigtion Pin 2 (Two Blacks) : Off = 0 ACC = 12 On = 12 Crank = 12 } = AcCessory Pin 3 (Yellow) : Off =12 ACC = 12 On = 12 Crank = 12 } = 12V DC Constant Pin 4 : Emptied Pin 5(Two Whites) : Off = 0 Acc = 0 On = 0 Crank = 12 } = Starter Pin 6(White) : Off =12 ACC = 12 On = 12 Crank = 12 } = 12V DC Constant Pin 7 (Gray) : Off = 0 ACC = 0 On = 12 Crank = 12 } = Ignigtion Connection : (Viper 4706 guide) 8 Pin connector      Pin 1 RED / Black (12 V) connected to 12 V on the dash fuse box            Pin 2 Pin/Black. No use Howeii recommendation      Pin 3 Pink/White +(Ignition 2) connecting to Gray (Pin7)      Pin 4 Red (12VDC constant input for ignition 1 Relay) connecting to 12 V at the dash fuse box      Pin 5 Violet Starter output connecting to Pin 5 at the key switch 8 pin plug.      Pin 6 Orange (Accessory output) connecting to Pin 2 at the key switch 8 pin plug.      Pin 7 RED / White (+ 12 VDC Constant input for ignition 2 and flex relay) connecting to the 12 V at the Dash Fuse Box      Pin 8 Pink (+ Ignition 1 Input/output) connecting to Pin 1 at the key switch 8 pin plug.

Main Harness 6 pin connector from Viper     H/1 Red (+ 12VDC Constant input) Connectin to the 12V at the Dash Fuse box.     H/2 Black (-) Chassis Ground Connecting to kick-panel ground     H/3 Brown (-) 200mA Horn Honk output (Didn't use because of the DBALL 2)     H/4 WHITE/ Brown Light Flash isolation wire-pin 87a ligh flash relay (Didn't use)

    H/5 White pin 30 of light flash relay connecting to the pin 18 of the white 20 pin plug connector (Viper diagram)

    H/6 Orange 500mA ground When Armed Output (Didn't use because of the DBALL2