’95 Ford Mustang alarm/remote start

hope the post above help

Thanks, I just have one more question about that. My A/C still doesn't work, everything else does. So I have a pink wire going to my Ignition 1, which is Tan/white. Then there is ignition 2 or acc 2 thats pink/white going to my Ignition 2 which is BLACK/ green. Then theres a gray wire going to my ACC/AC going to one gray wire out of 2 gray wires that are there. From what I am seeing you want me to connect 85 to my black /green wire as well as getting that back to the alarm (gray wire). Am I way off? Can you tell me what goes to what? Thanks so much.

Ignition Switch Layout: Ignition #1- TAN/WHT.............Powers Ignition Coil (Primary Ignition)

Ignition #2- GRY/YEL.............Powers Blower Motor(2) * Ignition #3- GRY/YEL.............Powers Trans. Control * Ignition #4- BLK/L GRN...........Powers Heat-A/C Controls * 2 Of These 3 GRY/YEL Wires Are One Circuit

From your RS/Alarm:

#1- TAN/WHT = PINK from RS/Alarm

#2- GRY/YEL = PINK/White from RS/AlarmRELAY1:PIN 87 = YELLOW @ Ignition Switch + ConstantPIN 87a = xxPIN 30 = GRAY / YELLOW @ Ignition SwitchPIN 85 = Negative while Running from RS/AlarmPIN 86 = Constant 12 volt ( + )

RELAY2:

PIN 87 = YELLOW @ Ignition Switch + ConstantPIN 87a = xxPIN 30 = BLACK/ Green @ Ignition SwitchPIN 85 = Negative while Running from RS/AlarmPIN 86 = Constant 12 volt ( + )

MO

Don't Learn from Others Mistakes

You Might Be the One That Knows.