Pioneer Speaker 12

Home / the12volt's Install Bay / Car Audio / Pioneer Speaker 12 (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Page < Prev Topic Next Topic >

xtremej

Gold - Posts: 1,440

This member has made a donation to the12volt.com. Click here for more info.

Joined: February 24, 2006

Location: United States

Posted: March 29, 2006 at 1:52 PM / IP Logged

What kind of amp, some are greatly overated.

Back to Top

doomsday123

Member - Posts: 11

Joined: March 27, 2006

Location: United States

Posted: March 29, 2006 at 2:31 PM / IP Logged

Probaby this one.

http://www.kenwoodusa.com/products/ListProduct.aspx?k1=2&k2=42&k3=155&pr=2012

Back to Top

lildave2467

Member - Posts: 1

Joined: May 27, 2006

Posted: May 27, 2006 at 1:46 PM / IP Logged

The amp you have chosen is a mono amp as well most class D amps are. As Velocity Motors said get two 4 ohm subs and run them in parallel this will give you a 2 ohm load on your amp. The only problem that I see is that Pioneer dose not make a sigle 4 ohm sub any more except for there new Shallow-Mount Subwoofer. You could go with 2 sub that have dual 2 ohm voice coils but once again pioneer dose not make one except for their high end stuff. I have 1 12 pioneer 3004spl in a custom built box vented box with a JL E1800 and I'm hitting a lot harder then most people with 2 12's.

Back to Top

Brianas

Copper - Posts: 50

Joined: July 15, 2005

Location: United States

Posted: May 27, 2006 at 3:48 PM / IP Logged

I would like to offer you a suggestion

I sell and install all these different models

very good bang for the buck

go for one premier ts-w3004spl and the gm-d510m amp and

a large sealed box ( 1- 1.5 cu. ft.)

i have been very impressed by this combo

low frequency extension is phenominal

would not recomend the 7150\7200 pio amps or kenwoods

g/l

Josh

JB Customs

Back to Top

gavin9797

Copper - Posts: 106

Joined: April 26, 2005

Location: Canada

Posted: May 28, 2006 at 10:56 AM / IP Logged

In answer to your question about the mono amp. No you do not need 2 mono amps. (not saying the the other amp is a bad choice either.) Refer to www.bcae1.com and look for the heading series/paralell. This should give you the information you need to make your decision.

Back to Top

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Pioneer Speaker 12

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.