2004 v4 camry, viper 791xv

Hi all,I have a 2004 V4 Camry. I had the viper installed for about 1 month ago. Everything was fine until today. When I was trying to install a window rolling module, I accidentally unplug (the car battery is still connected) a harness on the satellite relay module. You can see in the picture, the harness that I circled I tried to plug it back in but it does not work. Every time I try to plug it in, the starter start cranking and staring the car.AFter the car has started, I still hear some strange sound coming from the engine compartment. I think maybe the starter making that sound. If I unplug harness, the engine die immediately.Anybody have any ideal about what should I do to get it working again?Thank you so much for your time.

Small point, remove the unit's power fuses, reconnect and then re-insert the fuses.

Howies on the same path as myself. Vipers, like most units, need to see ground before all other wires.Prepare your future. It wasn't the lack of stones that killed the stone age.

Big Dog you're so right, years ago I was taught to ALWAYS conect ground first also an an anti-static measure,  some makes won't even work properly unless the ground is connected (and properly even to scraping down to bare metal) first.

Problem solved my friends. The main plug is a little bit loose. Thanks so much.

Big Dog wrote: I think that you must have slightly unplugged the 12-pin connector on the main module by accident or moved it so that the module doesn't see ground. Re-insert the 12-pin correctly before connecting the 4-pin harness.

I love it when I'm right.

Prepare your future. It wasn't the lack of stones that killed the stone age.

Hi there, right now Im trying to put the window module into my 04 camry. I bought the asianwolf module. Here is its manual: http://wolfcominnovations.com/images/vs/acc/pw400/pw400wiringdiagram.jpgAccording to the manual, I have to find the wires that roll up (or down) for each window. For example, I found out that the GREEN/ YELLOW in this picture is the roll up cable for the rear-left window. But the thing is I dont know where to cut the cable so that I can separate one switch side and one motor side. I did cut that wire right next to the blue plug into half. Then I measure continuity between the 2 half of that wire and the multimeter says they are still connect together. How can that happen? Are they still connect together at somewhere else? I was thinking about cutting right at the switch but then I have to route the wire from the module all the way to the switch. Is there any way we can do that. I try to avoid open the whole door panel to look at the cable(I just dont want to break anymore clips)Right now, I can control 4 windows using the driver switch. Will this feature still working after I put the module in?For the driver window only, right now I can either manually roll down the window or push the switch deeper for the one-touch full travel something to make the window roll down automatically. I heard that we have to wire something more so that we can have this feature working with the new module. Is that true

Big Dog.. would you happen to know where I can get a wire diagram for an 2002 Lancer to hook up a DEI 530T? thanks