791xv, 1995 ford f 350 diesel

Hey guys, Im trying to get this system working in my truck. Its a 1995 ford f 350 diesel. I have everything working except the remote starter. I cannot seem to find the tach wire. The bulldog security site says its a WHITE/ pink wire coming from the pcm. I found this wire but im not sure if its the right one. I cannot get the tach tought to the system. Will the tach wire show anything on my multimeter?

yes it measure up to about 6 volts. set the meter to AC.

Thanks alot for the respones. Then that wire is definetly not the tach wire as it doesnt show any voltage. The wire diagram says the tach wire is a pink wire located near the idm. Ill try and hunt that one down. Thanks again

Hey guys. I got the remote start to start the truck and keep it running. My only problem now is the ac doesnt work with the remote start. The accessory wire in my truck is grey / YELLOW. I ahve three grey / YELLOW wires. I tapped into two of them with my two acc wires. What about the third? Can I simply splice it into my second acc? Another problem im having is with my power door locks. I have a 5 wire reverse polarity system. I tied them in with 2 5 pin double throw relays and they dont operate with the remote. I got the diagram from an installer and im certain i wired them exactly as his diagram shows. What could be the problem with that? Thanks

on the satilette relay it has 4 wire harness they are for if yuo need another igntion, ACC, or starter. are you sure you got the right door locks wires

Alright, I was wondering what that other harness was for. As far as the door lock wires, yes they are the correct wires. I tested them with a multimeter.

That how I have it wired..

doulb check your wiring. also check the relays to see if they are ok.

I can power all the 12v one from one feed, right?

yes u can power al the relays form the same source. once you cut the wires did the locks work. they should nto work. jus tmaing sure you go tthe rigth wires